- X-6 CUBED ASSEMBLY INSTRUCTIONS -
Previous - Table of Content - Next
BAG C - REAR SHOCK TOWER
C1) Install the wing mounts first. You will need the Rear Shock Tower (XF3315), Wing Mounts (XF 3500), and Wing Mount Spacers (XF 6806).
C2) Place two 4-40 X 5/8" cap head screws (long arrows) through the left wing mount holes. There are two sets of holes; here we are using the lower set. Consult the Setup Sheets and Tuning Section to determine which you want. Then put two Wing Mount Spacers over the bolts (short arrows).
![](images/X63_Manual_img_51b.jpg)
C3) Install the one wing mount, then the other.
![](images/X63_Manual_img_52b.jpg)
C4) Place the Rear shock Tower (XF 3315) over the Rear Bulkhead (XF1313). Make sure the tower and bulkhead fit together properly (arrow) and the bolt holes line up.
![](images/X63_Manual_img_53.jpg)
C5) Place the Ball Stud Lands (XF 3800) on the shock tower, then install finger tight with the 5/8" flat head screws (XF 6024) If you use thread lock, put a drop now in the lower tapped holes of the ball stud lands to prepare for inst. C6..
![](images/X63_Manual_img_54a.jpg)
C6) Turn the bulkhead over and install the two 5/8" cap head screws (XF 6004) with flat washers (XF 6080). Now tighten the flat heads from C5.
![](images/X63_Manual_img_54b.jpg)
C7) Check the Set-Up Sheet and Tuning Section. Install the two ball studs you saved with any washers. We used the #2 hole with dialed Real Men Wear Black 0.030” steel shims.
![](images/X63_Manual_img_55b.jpg)
Previous - Table of Content - Next
|