In Part 5 of our Tekno EB410 build, we'll be
attaching assemblies to the beautiful chassis. This includes the front
and rear clips, center diff and all the miscellaneous bits that hold
these pieces together.
Build Notes:
*
In Step 3, the manual shows the chassis brace being installed before
the center bulkheads. Because the brace surrounds the front drive axle,
it was a bit challenging to get this all in place. I rearranged the
build slightly to make it easier. You'll see what I mean. |
Step 1:
Using two M3x10mm and two M3x8mm screws, attach the front end assembly to the chassis. Once secure, attach the front bumper.
A small dab of the blue threadlocker on the bumper screws is suggested.
Step 2:
Attach the battery stop...
Step 3:
…followed by the aluminum and plastic center bulkheads. Note the direction of the plastic bulkhead.
Step 4:
Press a 10x15mm bearing onto each side of your center diff followed by
the plastic diff wedges. As the instructions show, make sure the rounded
edge of the wedges are pointing down.
Align the front drive axle into the front bulkhead outdrive and
center diff and drop the diff into place. Make sure the diff is seated
correctly; you can check this by rotating the drivetrain. It should be
buttery smooth without any binding.
Attach the center bulkhead cap, using blue threadlocker on the two M3x8mm screws that feed into the aluminum.
Step 5:
Attach the plastic chassis brace.
Step 6:
Attach the two chassis braces to the rear bulkhead.
Note: For the kit build, you will use the inserts with the hole in
the UP position. If you decide to run either (or both) of the bulkhead
risers, you will need to adjust these risers accordingly.
Step 7:
Align the rear drive axle into the rear bulkhead outdrive and center
diff and attach the rear bulkhead assembly to the chassis with eight of
the M3x10mm screws.
Check the drivetrain for binding by rotating it a few times. If it
seems a little tight, that's ok; Tekno has stated that the gear mesh
might be tight for the first couple of battery packs.
WOO HOO! It's all starting to come together! Clean off some space and get ready for the next step - the shocks!
Use the links below to follow each step.
- Opening Page
- Part 1 - Differentials
- Part 2 - Steering and Bulkheads
- Part 3 - Rear Suspension
- Part 4 - Front Suspension
- Part 5 - Chassis
- Part 6 - Shocks
- Part 7 - Final Assembly |
