- Bag J - Electronics Build -
Previous - Next
Bag J is for the installation of the electronics. It contains all the parts needed to install the steering servo, motor, electronic speed controller, receiver and the battery.
My build notes:
When installing the servo horn, make sure the servo is set to neutral and install the servo horn at 90 degrees.

Use the right servo spacers, the bottom of the servo must not touch the chassis.

Don’t confuse the motor screws and the gear cover screws.

If you need more room to install your ESC and receiver, you can use the ESC mount included in the kit. Otherwise don’t use it, it will increase your buggy’s CG.

You can mount the antenna at the right or at the left side. Use the side closest to the receiver.
The foam that goes in the bottom of the battery box is self-adhesive. I didn’t peel it off because I want to have easy access to the servo wire.

Different battery spacers are included to use with saddle packs, square packs or shorty packs.


Previous - Next
Source:

|