RC10 B3 FT dry bumpy astro setup!

Just in case it's of any use this is how my car was setup at Mendip.

Front end
30wt, No2 pistons, blue springs, 19mm ride height.

Rear end
27.5wt, No2 pistons, silver springs 19mm ride height.
Long wheel base
3-3 toe and anti squat (standard)

Full stick pack Intellect 5900 and 50g weight stuck in the car mainly around the servo and 10g around the back corner of the chassis.
TMG front bulkhead, battery brace and rear trans brace.
JC racing +2mm driveshafts to allow a bit more droop than the factory amount of zero. I used AE +2mm shock eyelets to get the shocks a bit longer.

I did also run a bigger (84T, 22t pinion) spur gear for Worksop to get the motor far back and left it on for Mendip and that worked well. Motor was a 10.5 hobbywing.
Tyres just yellow Mezzo with tubby foam, cut staggers (not glued down) just glue on the side walls.