The Build - Part 2
The next couple of steps have us prep the chassis on the Team Associated B64 Club Racer.
Build Notes:
» Blue threadlocking compound is suggested on quite a few steps from here on out. Have some available to avoid any screws falling out while running your B64 Club Racer.
Step 1: Attach the side rails to the aluminum chassis and add the battery post to the right rear as shown.
Step 2: Attach the pair of aluminum servo posts and the battery strap mount. A dab of threadlocker on the screws going into the aluminum posts is recommended.
Step 3:Attach the aluminum and plastic center bulkhead pieces. Blue threadlocker is suggested into the aluminum part.
Note the red arrow; this shows the orientation of the notch on the plastic bulkhead. It should be facing the aluminum mount.
Step 4:Slide a 10x15 bearing on to each side of the center diff and drop it into place (note its direction). Give it a spin to make sure there is no binding, then attach the center bulkhead cap. Blue threadlocker is suggested here as well.
That was a few easy steps for prep - let's move on to the steering.
Opening Page
Part 1 - Differentials
Part 2 - Chassis
Part 3 - Steering
Part 4 - Front Bulkhead
Part 5 - Front Suspension
Part 6 - Servo
Part 7 - Rear Bulkhead
Part 8 - Rear Suspension
Part 9 - Turnbuckles
Part 10 - Shocks
Part 11 - Electronics
Part 12 - Body, Wheels and Tires
|
