Front

2 degree caster blocks
1mm shim on outer front ball stud (camber link stock location)
1 mm shim under front lower a arm suspension holder
2 degree inboard toe in the front
.75 degree toe out on each front wheel
go to 4 degree blocks in the front and keep arms flat for more all around steering
1.6 front sway bar
front sway bar inside position on arm
2 holes pistons
500CST shock oil front and rear 80% rebound
orange spring front
shock next to outer hole on front shock tower
front shock position outside on arm
5 mm ride height front and rear
Front one way 34 tooth gear (overdrive)

Rear

1mm shim inside camber link rear and 2mm shim under outer on hub (rear camber link all the way long)
4 hole Pistons rear
500CST shock oil front and rear 80% rebound
2 degree tow block rear
not using rear sway bar
yellow spring rear
shock next to outer hole on rear tower
rear shock position middle hole on the arm
4 mm of spacers in front of rear arms (increase wheel base)
5 mm ride height front and rear
rear ball diff loose but no slip

sorex 24 tires premount
mazda 6 body for extra rear bite or parma alfa to lossen the car up a little
all aluminum screws above chassis
need to add 90 grams if you use the aluminum screws
Mazda body mounted 33.5mm from center post to windshield
3 mm droop all the way around on the blocks
Paragon FX traction compound-tire warmers at 150 degree front 160 degree rear
CO27 30/102 4499 brushes
Trinity 4600 Enrich power