Here is MMR Driver Mitch's A Main Rubber Setup 13.5

ROAR Nationals at the Hobbyplex, Omaha, NE.

Novak 13.5 Brushless
Novak GTB
Molzer Mowery Bracket Cells
Parma Alfa 10074

Front

Servo saver ---- inner short
Shock ---- 3 hole piston, kit oil (500 cst), orange spring
Front axle ---- one way
1.5 degree camber, 5 mm ride height
Front block ---- 1 degree
Rear block ---- 0 degree
Wheelbase set at min, all washers in front of the arms
Inside upper link mount ---- inside rear with 2mm spacer
Arm mount hole for steering link ---- short
Front c-hub ---- 6 degree with 1 mm spacer under upper link
Upper shock mount ---- 3rd hole in
Lower shock mount ---- outside hole
Downstops set to produce a 9 1/2 mm ride height at full extension

Rear

44/96 gearing
Front block ---- 0 degrees
Rear block ---- 3 degrees
Upper link--inner mount inside with 2mm spacer, middle hole on the hub, 1mm spacer
Wheelbase ---- 4mm in front of the arms (max rear wheelbase)
Shocks ---- 4 hole pistons, kit oil (500cst), yellow spring
Rear axle ---- gear diff medium oil
Rear upright ---- 0 deg
Upper shock mount ---- 3rd hole in
Lower shock mount ---- middle hole
Downstops set to produce 8 1/2 mm ride height at full extension
2 degree camber 5mm ride height