This information is for all ProStock drivers, and everybody who wants to step into the Awesomatix ProStock class with the 17.5T Motor in the next ETS season. As we mentioned in our latest video, the software is not 100% ready while we are still working on some modes and values.

But if you already like to go testing, you can use the software which was in use in the 17.5 Stock class in the last season. We will use the same RPM Limiter, just with the longer gearing of 3,8. So you can already practice and test for the ProStock class with this software. The only modifications we will make for the start of the season is to reduce the adjustability of some other modes like PWM frequency or Punch. Here we will also go for a more easy speedo setup where racers don`t have to try too many different ESC setting options!

Just click onto the link below and navigate all the way down to the download section on the product page. There you can Download the 17.5T Software V1.4 from the last ETS Season for your practice sessions.
Keep in mind that this “old V1.4” Software is NOT the final version for the new season! As soon as the new software is completeley ready, we will provide it for downloading there as well!

ORCA BP1001-ETS 1.4 13.5 / ORCA BP1001-ETS 1.4 17.5

If you have missed out on our video about the actual testing stages of the softwares and motors (also 21.5T), just watch the video again and update yourself. Information and software for the 21.5 classes will be available soon as well!

We just revceived the new ORCA Software for our ETS stock touring car classes. You can download your software here to use it on track as soon as possible. We have tested many different settings and RPM limit values, and in the software you will get the values we liked the most during testing. Before you run with the new software for the first time, we like to give you some information about it.

The new Software comes with less values to adjust, for less confusion and more fun on the track. You can adjust the following values on the Speed Controller: LiPo Cutoff | Punch | Drag Brake | Brake Force | Brake Punch | Dead Band

The “PWM Frequency” is now pre-installed to the values 8000K for driving, and 1000K for braking. We found out that these values are working good in all conditions so there is no need to change them. We also removed the paramers “Running Mode” and “Reverse Force” as nobody used these setting options at all.

Important: You must update your programm card to the NEW 6.2 Software which is also included in the download package.

ORCA BP1001-ETS 3.0 17.5 / ORCA BP1001-ETS 3.0 21T5 / ORCA ProgramCard 6.2-230419A