|
How I check Ronald Volker RC car in between run's:
Step 1.
Bulkhead's has to be straight. That has to be checked only when having a hard crash or building the car.
Step 2.
Important: Chassis on the setup board.
Adjusting caster with the tools and double check with the height of the upright levers with a caliper.
If it doesn't fit a 80% I only tighten 1 screw firmly and and push slightly where I want it to have before tighten the 2nd screw.
Step 3.
Checking if the chassis has tweak with putting the car on blocks and lift up the rear with a screw driver. Looking from behind, the chassis has the lift equally left and right.
Step 4.
Checking ride height with race tires.
Step 5.
Checking camber and toe front and rear.
Step 6.
Checking steering angle.
Step 7.
Checking downstop front and rear.
Step 8.
Checking anti roll bar play without shocks. Both sides has to lift at the same time.
Step 9.
Checking the spring pre tension. Lifting up rear and front wit a screw driver in the center, both setup wheels has to leave the board at the same time.
Step 10.
Re-checking the ride height again in case the spring pre tension was changed in step 9.
|
