Caution: Please check below matching chart before SHR program card and ESC firmware update.
If using improper firmware may cause failure.

Download "FLETA_USB_Link_V1.8.zip file.

Click 'Next' Button

Click 'Next' Button

Click 'Next' Button

Click 'Next' Button

Click 'Install' Button

Installing 'FLETA USB Link V1.8 program in the PC'

When the installation is complete, THE USB Driver setup screen appears.

Click 'Next' Button

Check the 'I accept this agreement' and Click 'Next' button

Click 'Finish' Button'

Installed 'Muchmore Racing FLETA USB Link V1.8 program in the PC'

If you cannot install to PC. Check the compatibility.
[FLETA USB Link V1.6 How to used ]

Do not forget to disconnect the battery with the connector when the PC connect the program card certainly.
Please pay attention to this point especially, connect +,- has been causing huge damage.

Caution 1: If you use KO Propo`s Receiver, Remove ESC connector from your KO PROPO`s receiver.

Caution 2: (If you use FLETA PRO V2 or FLETA M8 ESC). Before connecting USB cable to your PC, make sure switch position is ON.

Caution 3.(If you use FLETA EURO V2)
Firstly connect the battery with ESC, then connect SHR program card with ESC.
Click ESC at Device section, turn on ESC.
(Caution: Do not disconnect the battery before firmware update is complete.