|
It is Hisama of the
2007CRC support driver. This time we report the race which after the May
consecutive holiday was done with the Kurume Nakamura model.
May 12th cellulose nitrate
In
order that the result in consecutive holiday is put out, it is the
cellulose nitrate which desired but trouble occurred immediately before.
It is the intention of having managed briskly, but the lithium polymer
electric battery for another power source expanded with overdischarge
and made useless. Urgently, transplanting the lithium polymer electric
battery which has been attached to the touring car, somehow it tried to
be able to travel. With output ability, the same time using in the
lithium polymer in order for there to be also some which become
overdischarge tendency, in the future the one which is managed more
severely is appealing.
Perhaps, with the picture it is difficult to know, but it is the
electric battery which expands. It is regrettable, but it is reuse
impossible.

Cellulose
nitrate it is, but because with advance practice it is running with the
tolerably feeling, nothing doing to die, prepares for preliminary round,
modification of setup. First or 1 heat eyes, it is super practice, being,
it was travelling at rather good pace, but the occasion where the front
running car is passed contacting & stacking and it falls down least
significant. Doing again to take the air, 2 heat eyes, opening although
at good pace it runs shooting in rapid succession detailed mistake. The
imai [chi] without being connected it became end.
Decision became travelling with B
main. Tolerably travelling was possible here, but the time already super
it pushes from the top it became goal slowly at 2 rank of 5 second lag.
May 20th monthly race
With
the cellulose nitrate of last week the tolerably completion, then the
road surface condition and the driver it does the car and itself is to
be it seems the way. With practice travelling in morning it is very the
road surface condition, but while feeling concern about abrupt road
surface grip rise, to preliminary round 2nd with set starting running
partly due setting up the tire.
Preliminary
round 1st time
<Front>
HR-38
& CRC-[MAZENDA]
Tire
diameter… 42.4mm
Grip
medicine… my tea gripper
Coating
width…Inside 9mm (reaction time 5 minutes)
<Rear>
HR-38
& CRC-[MAZENDA]
Tire
diameter… 43.0mm
Grip
medicine… my tea gripper
Coating
width…Extensively (reaction time 15 minutes)
After
all it seems that grip rises preliminary round 1st in comparison with
set. The feeling where the front tire is twisted does, but finishing to
run safely, provisional 4 rank. There to be also detailed mistake, also
the margin which still stuffs the time it may be, because is, with as an
opening of race it is very good impression touching.
Preliminary
round 2nd time (modification point)
<Front>
tire diameter… 42.0mm
Coating width…Inside 8mm
<Rear>
tire diameter… 42.8mm
Tire
diameter to call, because it is feeling, preliminary round 2nd time the
same tire was used. In order to hold down the being twisted of the front
tire, the shoulder inside and outside is cut a little slantedly. 1mm
decreasing the coating width the front, adjusting the movement where the
inside of cornering is stinging the direction which the spatula it does,
it is starting running. Also fine control was decided according to image
and the time raised somewhat, from the top at the preliminary round 5
count of 8 second lag the slide included increased to A main. Because
per 1 minutes it is 1 second difference in the simplicity calculation,
at all it is delicate position, but while faintly expecting, it enters
into the preparation of decision.
It
is grip medicine coating width of the tire, but in order to make
quantize have tried to manage with the number. Because it is job with
eye estimate, to be different in left and right, because 1/3 1/3 is a
possibility with 1/3 or less 2~3mm of changing strongly, using the slide
caliper, left and right have tried to adjust.

If
the line is pulled with the pen of silver, because boundary is clear, it
became easy to manage rather. Writing tire diameter what, because it can
retain, the various treasure it has done. Will the one which has
interest probably be trying searching at foam/home center and the
sentence tool store etc, how?
Decision (modification point)
<Front>
tire diameter… 41.4mm
Caster
shim…F0 /R3
<Rear>
tire diameter… 42.0mm
Before
the decision, the shim equivalent of 1 being able to lay down the caster,
it decreases the stall impression at the corner latter half, it is
deciding start. The top 2 unit somewhat, difference 1 units of certain
ones exchanging, surfaces to 4 counts. While doing 3 rank dispute, at
5th lap final stage it stopped bending suddenly on the right, not
meeting retiring became. . When you look at the car, the front tire
searching, it has peeled in direction. Hard because there is no either
remembering which is hit in the suspension arm it is improbable. When
you see carefully, the screw loosening, the tie rod had come off every
ball.

In
order to be able to adjust bump steering, because the screw stop
medicine was not used, perhaps it has loosened.
Decision
it was retiring, but because it could make according to image such as
fine control and race carrying of setup, it does well and with they are
the contents which we would like to think. As for next in order to be
able to leave the result, you are devoted.
Ken Ichiro Hisama |