- Yokomo B-Max2MR - Mark Headling - How to fit BM-008R arms to your B-Max2 -



Here is my quick guide on how to fit BM-008R arms to your B-Max 2.

As you can see these are the parts your need for the conversion
  • BM-008R arms
  • 2.6mm bolts for outer hinge pin
  • 1mm shim for rear hub spacing
  • A Dremel!

Dremel the rear of the arms as per pic to 33.92mm (measure you original arms to be sure)

Dremel the arms down to the same size as the original arms

Fit as per normal, make sure they clear the rear hinge pin brace and the arms fall under their own weight

Fit hubs as per normal but use one std 1.3mm shim and you'll need a 1mm shim as the BM008 arms are a bit narrower than the kit arms


Bolts to hold in the outer hinge pin, the kit ones are too small, you'll need 2.6mm bolts for the BM008 arms, I used tamiya ones but yokomo bmax 4 II bolts will be perfect


Finished:


Note: re check your camber and wind down the spring collars to raise the ride height back to normal 18-20mm


Source:

M. Headling