Batley Super Cup: Slippy floor and
carpet, plus some rippled mats.
Front
- Blue Spring
- Additional 57 hole in piston
- Oil 35wt
- ball joint done up on shock just
showing thread
- push rod turnbuckle - 34mm -
mounted on top of rocker
- top wishbone about in the middle
(equal spacing front/rear)
- ride height - slightly lower
than the back
- max droop
- Roll bar in long link (rear hole
in wishbone)
- camber 1 deg
- Slight toe in
- Standard wing with 2mm spacer
under rear mounting hole
Rear
- White/Silver spring with
compensator spring
- lower mounting hole on wishbone
- Additional 57 hole in piston
(standard one is about 57 also)
- 30wt oil
- Lower hole on the hub (high
position)
- Roll bar in short link (rear
hole in wishbone)
- wing forward half gurney
- toe-in 3 degs
- 1 deg camber
- ride height - wishbone level
- max droop
Extras
- Motor LRP X12 6.5 (20/72), LRP
Sphere Comp ESC
- One-way shaft - three o-rings on
brake bias
- Bumper cut down to improve
ground clearance on landing jumps
- Cone washers on top of front
hubs removed and replaced with two 1mm washers underneath the
wishbone and 1 on top.
- Rear anti-roll bar lowered
- Schumacher Mini-pins - yellow
compound with blue foams/inserts
- Cut the inner two rings off the
surface of the rims
- Stick Lipo conversion (5000mah
lipo set far forward as possible)
|