Here is the setup i finished up
on at Worksop.
Front
Track Washers - 1mm front and
back
Camber - -1°
Roll Bar - No
Shock Position Mount - Middle
Shock Position Wishbone - Middle
Front Rake - 10 Degrees
Washers - 3mm
Front Link Bracket - 43mm
Washers on Hub - 0
Rear
Wheel Base - Short
Camber - -1°
Toe In - 3mm Rear, .5mm front = 3.25 degrees
Anti Squat Washers - 2mm Rear, 1mm Front = 1.3 degrees
Rear Link Bracket - 37.5mm
Washers - 4mm
Shock Position Mount - Middle
Shock Position Wishbone - Inside
Hub Postion - Middle
Roll Bar - No
Shocks
Front
30wt on 3 Holes
Schumacher Red Springs (Old)
Diaphragm - Centre cut out and removed
Ride Height – Drive shafts level
Rear
25wt on 3 Holes
Schumacher Yellow Springs (New)
Diaphragm - Centre cut out and removed
Ride Height – Drive shafts level.
Transmission
Rear Diff Height - Low
Front Diff Height - Low
Layshaft Pulley - Pin Through
Front Drive – One Way
Gearing - 83 x 24 on Speed Passion 5.5
Internal Ratio - 36 Tooth Pulley
Tyres
Yellow Mini Pin all round,
Schumacher Green Inserts.