Front

toe in 1deg
camberlink long
camber 1deg
10 deg front hubs
no shims under d pivot point,

Shocks
40wt
pistons drilled 2x 1.5
springs orange
la43 3mm removed
no limiter
shock mount outer hole at top
on wishbone on inner hole,

Rear

la232 universal swing shaft
camberlink short on the inside long on the outside with kit washer
kit hole on hub
toe-in block a30
no 3 shim under front pivot block for anti squat
no sway bar

Shocks
30wt oil
2x 1.5 drilled pistons
yellow springs

Additional notes

76 spur gear 17 pinion 10x2
wing mounted central holes with max angle,full gurney flap
la43 is the bottom shock ball joint used on the front ball joint to create more droop we cut approx 3mm off of this so the car bottoms out before the shock does
weights 30gms on the chassis by the motor and 15 gms on the servo
cells in rear position