- Kyosho RB6 - Electronics Setup - Rear Motor -


page 2


Here's a pic of mine i made a piece out of lexan that drops down 4mm for a little extra clearance for the ko reciever


Here's how I mounted all the electronics: I flipped the receiver, cap, and switch on their sides and mounted them to the side guard. It doesn't look like it in the pic but there's a decent gap between the receiver wires and the battery. I was thinking about mounting the receiver above the ESC but would like to keep that area clear to give the ESC adequate cooling. We'll see how this holds up tomorrow.


Shorty lipo is the key. I went 1015 servo, then my airtronics receiver. Lipo and then the LRP SXX fit perfect with the cap hidden under the shock tower.nothing had to go on the sides. All balanced right down the middle.


The plastic battery posts with clips just irked me, so yesterday morning I modified the battery holder to accept my aluminum posts. Since I am running the standard lipo, I have a spare battery holder just in case I need to go back

Starting with the Japan setup with two minor changes. 0 degrees in the caster block (instead of 4) and .5 degree rear hubs (instead of 0).


New battery brace setup! works like a charm.. aluminum RB5 battery posts with 2mm shim underneath. I will end up cutting off the back inch or two as it doesn't go under the bulkhead (doesnt need to)


Kevin Tyler


Jared tebo (Jan 2013)


Atsuchi Hara (Jan 2013)


Tevor Williams


Richard Watchorn


Char Blanton


page 2

Source: