- Kyosho Ultima RB5 - Nathan Ralls - Worksop Indoor Setup - 2008 -

 

FRONT

oil 35 wt losi
piston 2c
spring lime green 75
shock tower kit middle
wishbone outer hole
inner camberlink middle hole +1mm washer
outer camberlink inner hole
hub height low (washers above)
kickup 25 degree's
weight 10g on top of servo
ride height wishbones below level

REAR

08 velvet body, kit shaft
oil 25 wt losi
piston 2b
spring mauve,blue (imt told 72 but not sure, spring that comes with the 08 rear end)
shock tower 08 middle
wishbone 08 inner
inner camberlink outer hole no washers
outer camberlink outer hole +2mm washers
08 hubs medium wheelbase (no height adjustment)
rideheight driveshafts level
wing in middle mount position

NOTES

shoulder cut off the front pivot balls for rear wishbones, 2 white washers placed behind wishbones to shorten wheelbase, car ran on nimhs but is normally on lipo with no additional weight (until i check it on scales) cells in forward position
kit wing with half gurney (flies very neutral)

car very easy to drive with bundles of steering, fronts and rear minipins run full with mr O medium foams, when outside inner and outer row cut off the front, full rear with same inserts

Source: