Here is the setup we were running at the
Factory Tracks Midwest Series. Ended up 3rd. Track was lower bite,
bumpy with light loam on top, and by the mains was grooved enough we
ran red tapers. Setup was dialed on both conditions.
Front:
2-A linkage (Middle on bulkhead,
inside on caster block), -1 degree of camber, no washers under the
ball stud.
25 degree caster, axles up.
Dark Yellow Springs (#60), Losi 32.5 Oil 2-B piston.
Shock ends at stock settings.
Shock middle on tower, outside on A-arm.
Stock bump steer.
Rear:
1-B linkage (Inside on bulkhead,
middle on hub ), -1 degree of camber, stock washer under ball stud (
3mm )
Dark Yellow Springs (#60)
Losi 32.5 2-C piston.
Rear shock ends unscrewed 1 turn.
Shocks middle on tower, inside on A-arm.
Hubs in the Middle.
Misc:
10x2 motor,
78- 18 gearing.
Battery in the Rear.
Pro-Line 8175 M3 fronts, with stock foam.
Red X-2000's with stock foam while track had a little loam, Red
Taper pins with stock foam when the track was grooved.
Ride height set arms slightly below level.
HI-Downforce Kyosho Wing.
Setup
Sheet in PDF Format
|