Here's my setup pretty close to what I ran at the snowbirds

Front end:

tamiya shocks
steel spool
xray oil 350
hpi gold springs
no swaybar
blocks used in the front were 1.5in the rear of the front and 1.5 in the front for no arm sweep
wheel base 2.5mm shims in rear and 1 mm shim in front
ackerman plate mounted in middle hole
1 mm shim under steering post
1 mm shims under ballstuds on bell crank
.5 shim under ballstud on c-hub
3.5 mm shims under front camber link inside to make camber link flat
droop 6 on gauge

Rear end:

0 block in front of rear
3 block in rear
tamiya shocks
xray oil 300
hpi springs silver
no swaybar
2 mm shim under inner ball stud on camber link
droop 6 on gauge

wheelbase 1.5mm shim in front of the arm
post under topdeck in front removed
chassis 3.5 mm us spec
topdeck 3.5 mm us spec
ko propo servo
spectrum pro reciever
losi speed control
hacker 13.5 105 spur 45 pinion
optional 1.9 pulley set

Car drove great and was pretty fast in the mains basically on my wheel base guys i set it up so the cvds are straight with no angle for less bind.

What about the roll center shims under the 1.5 front blocks and 0/3mm rear blocks?

0.5 mm shims under all blocks