Front:
+1 toe
-1.5 camber
4 degree c-hubs
3.5mm spacer on the back of the suspension arm
1B(front)-1A
upper connecting arm, 0.5mm spacer inside 0 outside
steering conn arm, 0.5 mm inside 0 on knuckle (I have square knuckle and
the rod was connected to the closest hole to the shaft)
40wt oil 3 hole pistons yellow springs
4.5mm height, 3mm droop
medium sway bar.
Ball diff
Rear:
-3 toe
-2 camber
0 degree hubs
2mm spacer on the front of the suspension arm
1XB(front)-1D
upper connecting arm, 0.5mm spacer inside 1 outside
40wt oil 3 hole pistons Red springs
4.5mm height, 3mm droop
Tires:
sorex 28 with hara black ver1 inserts excel dish wheels
No wheel spacers
KO 2413 servo, Molac ESC, CP 10x2 (the rotor finished before the final)
and CP 10x1 (was actually faster) I used one fan on the esc as I had cut
off problems and one was in between the motor and the esc. On the motor
I used an old Racetech water jacket which I soaked with cold water.
Gear ratio: 76spur, 24 pinion, 2.25 internal
|
