FRONT
gold springs
3mm spacer above upper arm, 1mm spacer below knuckle.
Steering links mounter on underside of knuckle in rear postion,
.5deg toe out
b3s with tamiya hard insert, 1/2 to 3/4 (depending on grip level)
pargaon 1min soak.
SHOCK
80wt w/ 3 hole white piston.
white spring with red dot (the ones that comes with the hop-up
shock)
2mm spacer under front shock mount
POD
flex pate t-bat w/ stock o-ring setup,
~ 2 turns tighter than factory setting.
50/50 mix of tamiya medium & soft friction grease w/ plastic
friction discs, springs adjusted for even light tension
Shock adjusted to make pod level with chassis.
~8oz total battery weight, 3200 lipo w/ 1 oz of lead centered
under battery
REAR
B3s w/ tamiya kit type foam strips
(the softest charcoal one) narrowed to 24mm.
paragon over full tire, 3min soak.
Diff set just tight enough to not slip w/ 2 spring washers
GEARING
23/104 w/ the kit included silver
can