Here is Derek Furantani setup for High
bite to medium bite asphalt...Great starting point , and pretty sure
it will work for the shin car. I have used this setup for stock, and
19 turn brushless...
Front
Spool or One way with AA diffs
Front block CCin , 2 mm spacer in front hidge pin, #3 spacer
underneath blk
Rear block CCin , 1 mm spacer in rear hidge pin, #3 spacer
underneath blk
Droop 5 with yokomo gauge
Camber 1.5 to 2 degree camber you choose, toe 0 to .5
Stock 3 hole pistons, 45wt kyosho oil, blue kyosho spring(I use
Tamiya gray)
1.5 mm spacer in Front top camberlink, use the back camber link hole
Shock position 2nd hole from bottom
Rear
Front block BBin, 2 mm spacer in
front hidge pin, #3 spacer underneath blk
Rear block DD out, 1 mm spacer in rear hidge pin, #3 spacer
underneath blk
Droop 4 with yokomo gauge
Camber 2 ( I look at ware of tire, I usely use 1 degree)
.5 spacer in rear top camberlink in far back hole
stock 3 hole pistons, 40wt kyosho oil, orange kyosho spring(I use
tamiya blue)
Total 3 degree toe
Shock position in middle of shock tower
AA rear diffs
We use Mazda 6 or Mazda speed 6 bodies
Tires RP30 out door or Sorex 36 with yokomo thin insert at Socal
Hopefully this will be a good starting
point