- CRC Carpet Knife V3.2R -

- Kazuo Ishikawa -

- 16/10/2005 - Yatabe Arena - All Japan Championship -

 

Front:

Tire: Yokomo ?? 41mm
Wheel: Yokomo
Traction compound: Inner Quarter - Half - 15 minutes
Spring: CRC 0.5mm
Shim: 0. 5mm
Caster: 10° variable (aluminum)
Camber: 1°
Axle: CRC nylon
CRC nylon upper arm
Toe: 0 degree
King pin shim: 1. 2mm up and 1mm down
Front ground clearance: 2.4mm

Rear:

Tire: JACO Blue 43mm
Wheel: CRC
Traction compound: ?  - 40 minutes
                                     then All - 10 minutes
Shock oil: #600
Damper length: 68mm
Roll dumper oil: CRC heavy (white cap)
R axle # 1
Side spring: white
Center pivot position (= CRC low roll center kit?)
Height: 2.8mm battery side, 2.4mm rear axles

Comments:

Lower chassis 3.2: 2.1mm

Approximately shim (intermediate state)

Motor: Orion V2 9x2
Motor brush: normal
Spur: 96 - Pinion: 29
Battery: LRP 3800 Fat Boy
Body: SP8
Spoiler blade tip board: 10mm

ESC: GM purple SX12WM
Receiver LRP PHASER
Servo: S9650
Using the remark strut bar the 2mm thick material

Both outside inside pyro ball of roll damper Installation section the shim of 2mmAs for strut bar 2mm thick mosquito I duck material use
Servo position from normal 8mm rear
In receiver power source lithium polymer use

For more information, visit Ishikawa website

Source : Kimihiko Yano