- Awesomatix A700 - Mark Dawson - Nice-to-have parts -

PRIORITY 1 - GOOD TO HAVE DAY 1

1. A single complete universal (Page 5) - haven't worn one out or had any failures - typically like to have spares for essential drivetrain components.
2. 1 set of either bronze, round or c-clip bushings (Page 5)
3. SPR07 - E-ring. Very tiny and critical to keeping the clips/bushings in place
4. QTY 1 - C04 Arm - haven't broken one to date but a good just-in-case
5. QTY 1 - P04 Lower Hub Mount - could elongate on serious crash
6. QTY 1 - P01/P02 - Specialized to the A700 and critical to front/rear suspension
7. QTY 1 - Ball End Set - Not specialized for the A700, Kyosho offer similar and upgrade HARD ends.
8. QTY 1 - Long Turnbuckle - the suspension has to have some place to absorb collision. Have bent/broken one of these.
9. QTY 1 - Short Turnbuckle - same as above.

PRIORITY 2 - UNLIKELY YOU WILL NEED RIGHT AWAY - BUT IF IT GOES BAD, YOU ARE PREPARED

1. QTY 2 - B106RS Bearings - haven't worn one out or had any failures - typically like to have spares for essential drivetrain components.
2. QTY 1 - SPR01 - haven't bent one - could potential straighten if needed
3. QTY 1 - SPR02 - haven't bent one - could potential straighten if needed
4. QTY 1 - P09 - frequent changes to suspension might wear plastic part
5. QTY 1 - Gear Diff Rebuild Kit - follow Olegs modification instructions. Surely may not have to rebuild a rear-installed gear diff. But if you run a front gear diff with putty - it might wear faster than the rear.
6. QTY 1 - Extra Spool - haven't worn one out or had any failures - typically like to have spares for essential drivetrain components.
7. QTY 1 - AT04 - Drive Shaft - - haven't worn one out or had any failures - typically like to have spares for essential drivetrain components.

PRIORITY 3 – CHECK TO REBUILD AFTER 1000 LAPS

1. QTY 2 - B106RS Bearings - haven't worn one out or had any failures - typically like to have spares for essential drivetrain components.

Source: