6th report of supported
driver Hawk from Aichi prefecture
This time in the main chassis of JSPEC
the rear mediation of Generation-X pre- the specification
which is installed (below JSPEC-X: It reports the [jiesupetsuku]
x) concerning.
* The rear mediation pre- specification of Generation-X
(Rear pod + rear bottom plate + rear X brace + rear top plate)
Furthermore, as for the latest
specification my
3rd report being simultaneous, 3 piece being linked and
converting side link.
Because the bottom plate of JSPEC
is not sold anymore, the one where the holdings are gone the
rear mediation pre- set of Generation-X by the fact that you
use, it can do the main chassis of JSPEC and to use around the
front.
* However, as for JSPEC-X, about approximately it becomes 5mm
long in comparison with normal JSPEC.
You can acquire the rear
mediation pre- set of Generation-X.
However, you must adjust size,
there is a place.
Coordinating point
1. Height adjustment of main
chassis and rear pod
2. Adjustment of center damper installation position and
length
3. Cutting modification [riahoiruachi] of antenna hole
position of body
Adjustment
1. In center pivot fixed screw part
the washer addition of 0.3mm
Because from the main chassis of
JSPEC, rear pod of Generation-X is a thickness, height of the
base flat (barrier free) is done with this washer.
2. Installation position of the
antenna mount is modified in hole position of the picture.
Cutting front
side of the ball end for center damper fixing to approximately
half
When the rear
mediation of Generation-X pre- it transplants, even from at the
time of JSPEC center damper installation position of the rear
top plate about 3mm, becomes the rear. (In the wheel base about
5mm, it becomes long)
Attendant upon
this, it is necessary to adjust damper length.
When that way is,
because the center damper stops reaching, it makes damper length
long, or modifies the installation position of the antenna mount
in the rear.
Because latter is
done, about 6mm, the offset, when the ball end for center damper
fixing is cut about 3mm, you think that it is good.
3. Cutting modification [riahoiruachi]
of antenna hole position of body
As for this we ask with the spot
goods adjusting.
|